01.In a coupling rod of a locomotive, each of the four pairs is a ________ pair.
Turning.
02. A pantograph is a mechanism with
Lower pairs.
03. A pantograph consists of
4 links
04.A Hooke’s joint is used to join two shafts which are
intersecting
05.A ball and a socket forms a
Spherical pair.
06.In a gear having involute teeth, the normal to the involute is
Base circle.
07.The sleeve or muff coupling is designed as a
hollow shaft.
08.The number of rivets in shear shall be equal to the
number of rivets in crushing.
09.When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
crown bevel gear.
10. In second type of levers,
where P=effort, W=load, F=fulcrum,
load is in between the fulcrum and effort.
11.In a flange coupling, the flanges are coupled together by means of
bolts and nuts.
12.A column is known as a long column if the slenderness ratio is
100
13.The value of stress concentration factor depends upon
material and geometry of the part.
14.An open belt drive is used when
shafts are arranged parallel and rotate in the same directions.
15. The pipe joint mostly used for pipes carrying water at low pressures is
socket joint.
16.Stress concentration is caused due to
abrupt change of cross-section.
17.The resistance to fatigue of a material is measured by
endurance limit.
18. In a flange coupling, the thickness of flanges is taken as
one-half the diameter of shaft.
19.The taper on cotter varies from
1 in 48 to 1 in 24.
20.The maximum normal stress theory is used for
brittle materials.
Turning.
02. A pantograph is a mechanism with
03. A pantograph consists of
4 links
04.A Hooke’s joint is used to join two shafts which are
intersecting
05.A ball and a socket forms a
06.In a gear having involute teeth, the normal to the involute is
Base circle.
07.The sleeve or muff coupling is designed as a
hollow shaft.
08.The number of rivets in shear shall be equal to the
number of rivets in crushing.
09.When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
10. In second type of levers,
load is in between the fulcrum and effort.
11.In a flange coupling, the flanges are coupled together by means of
bolts and nuts.
12.A column is known as a long column if the slenderness ratio is
100
13.The value of stress concentration factor depends upon
material and geometry of the part.
14.An open belt drive is used when
shafts are arranged parallel and rotate in the same directions.
15. The pipe joint mostly used for pipes carrying water at low pressures is
socket joint.
16.Stress concentration is caused due to
abrupt change of cross-section.
17.The resistance to fatigue of a material is measured by
endurance limit.
18. In a flange coupling, the thickness of flanges is taken as
one-half the diameter of shaft.
19.The taper on cotter varies from
1 in 48 to 1 in 24.
20.The maximum normal stress theory is used for
brittle materials.
No comments:
Post a Comment