Fitter Trade top 10 mcq on Riveting.

1. The height of the snap head rivet is standardized to

0.7 x diameter of rivet.

2. In a riveted joint the edges of plates are simply laid over each other and riveted.This joint is called

Lap joint.

3. In a riveted joint the plates are placed end-to-end and jointed through cover plates.This joint is called

Butt joint.

4. In a riveted joint pitch is the distance between two adjacent rivets in the same row,measured parallel to the seam. It is usually equal to

3 x Diameter of the rivet hole .

5. In a riveted joint the minimum distance from a rivet hole centre to the nearest edge of the plate is called

Margin.

6. A dolly is the name given to a category of tools used in

Shaping sheet metal .

7. Caulking and fullering are the operation done to make riveted joints

Leak-proof.

8. Which one of the following is a type of permanent fastener?

Riveted joint.

9. The centre to centre distance between two adjacent rivets in the same row, measured
parallel to the seam or edge of the plate is called

Pitch.

10. The minimum distance from a rivet hole centre to the nearest edge of the plate is called

Margin.