Thursday, October 18, 2018

MECHANICAL ENGINEERING MCQ SECTION 2






11.Deformation per unit length in the direction of force is known as

(A) Strain
(B) Stress
(C) Poisson’s ratio
(D) Modulus of elasticity

12.In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is

(1) more
(B) less
(C) same
(D) more/less depending on composition


13.The neutral axis of the cross-section a beam is that axis at which the bending stress is

(A) zero
(B) minimum
(C) maximum
(D) infinity

14.If there are L number of links in a mechanism, then number of possible inversions is equal to

(A) L + 1
(B) L – 1
(C) L
(D) L + 2

15. Automobile steering gear is an example of

(A) higher pair
(B) sliding pair
(C) turning pair
(D) lower pair

16. The fatigue life of a part can be improved by

(A) electroplating
(B) polishing
(C) coating
(D) shot peening

17. The notch angle of the Izod impact test specimen is

(A) 10°
(B) 20°
(C) 30°
(D) 45°

18. In most machine members, the damping capacity of the material should be

(A) low
(B) zero
(C) high
(D) none of these

19. A stud

(A) has a head on one end and a nut fitted to the other
(B) has head at one end and other end fits into a tapped hole in the other part to be joined
(C) has both the ends threaded
(D) requires locking nuts

20. For applications involving high stresses in one direction only the following type of thread
would be best suited

(A) ISO metric thread
(B) acme thread
(C) square thread
(D) buttress thread



No comments:

Post a Comment

FACEBOOK REELS VIRAL TIPS AND TRICKS

Here are the best tips and tricks to make your Facebook Reels go viral in 2025 — specially curated for creators like you 👇 --- 🔥 1. Hook i...